New Item.
For Honda Talon Owners looking to install a standard switch at any of the OVERSIZED factory switch holes. Most noticeable is the unused blank spot between the steering column and the headlight switch.
Talon R/X:
- Fits the blank beside the Headlight switch.
Pioneer 1000 Base Model:
- Fits the 4 large blanks or any of the OEM switches.
Pioneer 1000 Deluxe, Trail, Forest models:
- Fits to replace and of the OEM switches.
No instructions included:
To install, remove the lower steering cover by removing the 4 push clips holding it to the dash. Reach inside and remove the blank by squeezing the clips. Once removed, insert the adaptor and reinstall the steering cover. Done!
Collections: addon, ALL ITEMS, Electrical, Featured Items!, Home page, Talon 1000 R/X
I used this switch to take out the Factory oversized rocker Honda hill break to install a Hess Motorsports I four wheel drive delete it worked great
Perfect fit. It was a little stubborn when installing it, but that means it will stay put when the going gets rough, and it WILL get rough. Looks great - does not catch the eye or stand out in any way (in a bad way). I'm a happy camper.
I used in combination with the winch rocker switch so that I could mount higher next to the trans mode switch in the large switch blank. Looks factory. Nice tight fit. No slop.
This is a printed part and the fit is a bit tight but, once you get it in place it looks factory original.
I purchased the adaptor for my new Harbor Freight Winch control and it worked perfect. Exactly what I needed to mount the switch in the Honda dash without any modifications.